Honda CR-V: Windshield Washers

Check the fluid level in the windshield washer reservoir at least monthly during normal use.

Check the fluid level by removing

Check the fluid level by removing the cap and looking at the level gauge.

On Canadian models: The low washer level indicator comes on when the level is low.

Fill the reservoir with a good-quality windshield washer fluid. This increases the cleaning capability and prevents freezing in cold weather.

When you refill the reservoir, clean the edges of the windshield wiper blades with windshield washer fluid on a clean cloth. This will help to condition the blade edges.

Do not use engine antif reeze or a

Do not use engine antif reeze or a vinegar/water solution in the windshield washer reservoir. Antif reeze can damage your vehicle’s paint, while a vinegar/water solution can damage the windshield washer pump. Use only commercially-available windshield washer f luid.

READ NEXT:

 Automatic Transmission Fluid

Check the fluid level with the engine at normal operating temperature. 1. Park the vehicle on level ground. Start the engine, let it run until the radiator fan comes on, then shut off the en

 Rear Differential Fluid

4WD model only The rear differential should be drained and refilled with new fluid according to the maintenance messages shown on the information display. Have your dealer replace the rear

 Brake Fluid

Check the fluid level in the brake fluid reservoir monthly. Replace the brake fluid according to the maintenance messages shown on the information display. Always use Honda Heavy Duty Brake

SEE MORE:

 Brake System

Brake System Inspection and Test Inspect the brake system components listed. Repair or replace any parts that are leaking or damaged. Component Inspections Brake System Test Brake pedal sinks/fades when braking 1. Set the parking brake, and start the engine, then turn off the A/C switch. Allow th

 How to Set Readiness Codes

Malfunction Indicator Lamp (MIL) Indication (In relation to Readiness Codes) The vehicle has certain "readiness codes" that are part of the on-board diagnostics for the emissions systems. If the vehicle's battery has been disconnected or gone dead, if the DTCs have been cleared, or if the PCM has b

© 2016-2025 Copyright www.hcrv.net