Honda CR-V: Auto-tensioner Removal and Installation
Removal
1. Remove the chain case cover.
2. Turn the crankshaft counterclockwise to compress the auto-tensioner.
3. Align the holes on the lock (A) and the auto-tensioner (B), then insert a 1.2 mm (0.05 in.) diameter pin or lock pin (P/N 14511 -PNA-003) (C) into the holes. Turn the crankshaft clockwise to secure the pin.
4. Remove the auto-tensioner.
Installation
1. Install the auto-tensioner.
2. Remove the pin or lock pin (P/N 1451 1-PNA-003) from the auto-tensioner.
3. Remove old liquid gasket from the chain case cover mating surfaces, bolts, and bolt holes.
4. Clean and dry the chain case cover mating surfaces.
5. Apply liquid gasket, P/N 08717-0004,08718-0001, 08718-0003, or 08718-0009, evenly to the chain case mating surface of the chain case cover. Install the component within 5 minutes of applying the liquid gasket.
NOTE:
- If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
- If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
6. Install the chain case cover.
NOTE:
- Wait at least 30 minutes before filling the engine with oil.
- Do not run the engine for at least 3 hours after installing the chain case cover.
Chain Case Oil Seal Installation
Special Tools Required
- Driver 07749-0010000
- Attachment, 52 x 55 mm 077 46-0010400
1. Use the driver and attachment to drive a new oil seal squarely into the chain case to the specified installed height.
2. Measure the distance between the chain case surface and oil seal.
Oil Seal Installed Height: 33.0-33.7 mm (1.30-1.33 in.)
READ NEXT:
Cam Chain Inspection
1. Remove the front wheels.
2. Remove the splash shield (see step 21).
3. Remove the drive belt.
4. Remove the cylinder head cover.
5. Set the No.1 piston at top dead center (TDC). The
punch mark
CKP Pulse Plate Replacement
1. Remove the front wheels.
2. Remove the splash shield (see step 21).
3. Remove the drive belt.
4. Remove the cylinder head cover.
5. Set the No.1 piston at top dead center (TDC). The
punch mark
Cylinder Head Cover Removal/Installation
Cylinder Head Cover Removal
1. Remove the intake manifold cover.
2. Remove the four ignition coils.
3. Disconnect the evaporative emission (EVAP)
canister purge valve connector.
4. Remove the dipst
SEE MORE:
Operating the XM Radio
To listen to XM radio, turn the
ignition switch to the ACCESSORY
(I) or the ON (II) position. Push the
button to turn on the audio
system, and press the ‘‘XM’’ button.
Adjust the volume by turning the
VOL/SELECT knob. The last
channel you listened to will show in
the display.
Dual Deck Cargo Shelf
If equipped
The dual deck cargo shelf will
separate the storage area into two
storage areas. On the upper area,
you can store small and light items.
You should place heavy items in the
lower storage area. You can remove
the dual deck cargo shelf and store it
on the cargo area floor
