Honda CR-V: Fan Controls

Component Location Index

Honda CR-V. Fan Controls

Symptom Troubleshooting Index

Honda CR-V. Fan Controls

Circuit Diagram

Honda CR-V. Fan Controls

Radiator Fan High Speed Circuit Troubleshooting

1. Remove the fan control relay from the under-hood fuse/relay box, and test it.

Is the relay OK?

YES-Go to step 2.

NO-Replace the fan control relay.

2. Measure the voltage between the fan control relay 5P socket terminal No. 5 and body ground.

Is there battery voltage? YES-Go to step 3.

NO-Replace the under-hood fuse/relay box.

3. Check for continuity between the fan control relay 5P socket terminal No.2 and body ground.

Is there continuity? YES-Replace the under-hood fuse/relay box.

NO-Repair open in the wire between the fan control relay 5P socket terminal No.2 and body ground. If the wire is OK, check for poor ground at G301.

READ NEXT:

 Fuel and Emissions

 Fuel and Emissions Systems

Special Tools Fuel Sender Wrench Fuel Pressure Gauge Attachment Set Vacuum/Pressure Gauge, 0-4 in.Hg Pressure Gauge Adapter Oil Pressure Hose A/T Pressure Hose A/T Low Pressure

 General Troubleshooting Information

Intermittent Failures The term "intermittent failure" means a system may have had a failure, but it checks OK now. If the malfunction indicator lamp (MIL) on the dash does not come on, check for poor

SEE MORE:

 Column Cover Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. NOTE: Take care not to scratch the dashboard and related parts. 1. Release the tilt/telescopic lock lever, tilt the steering wheel to fully down, and pull

 Low Oil Pressure Indicator

Low Oil Pressure Indicator This indicator should never come on when the engine is running. If it starts flashing or stays on, the oil pressure has dropped very low or lost pressure. Serious engine damage is possible, and you should take immediate action. Running the engine with l

© 2016-2025 Copyright www.hcrv.net