Honda CR-V: Vanity Mirror
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Interior Convenience Items / Vanity Mirror
To use the vanity mirror on the back of the sun visor, pull up the cover.
Except LX model
The vanity mirror lights come on when you pull up the cover.
READ NEXT:
Sun Visor
To use the sun visor, pull it down.
When using the sun visor for the
side window, remove the support rod
from the clip, and swing it out.
Make sure you put the sun visor
back in place when
Sunglasses Holder
To open the sunglasses holder, push
then release the raised detent. It will
unlatch and swing down. To close it,
push it until it latches. Make sure the
holder is closed while you are driv
ConversationMirror
The sunglasses holder uses a convex
mirror for its bottom panel. You can
see all the vehicle passengers in this
mirror. To use the mirror, open the
sunglasses holder fully, push it to the
SEE MORE:
DTC P2122: Accelerator Pedal Position (APP)
Sensor A (Throttle Position Sensor D) Circuit
Low Voltage Input
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
1. Clear the DTC with the HDS.
2. Turn the ignition switch ON.
3. Check whether DTC P2122 is indicated in the DTCs/
Freeze Data in PGM-FI Mode Menu with the HDS.
Is D
Side Engine Mount Bracket Replacement
1. Support the engine with a jack and wood block
under the oil pan.
2. Remove the upper torque rod.
3. Remove the ground cable (A), then remove the side
engine mount bracket (B).
4. Install the side engine mount bracket, then loosely
tighten the new bolt and nut (C), and loosely tighten
the bolt
© 2016-2025 Copyright www.hcrv.net
