Honda CR-V: Opening and Closing the Hood

1. Park the vehicle, and set the

1. Park the vehicle, and set the parking brake. Pull the hood release handle located under the lower left corner of the dashboard.

The hood will pop up slightly.

2. Reach in between the hood and

2. Reach in between the hood and the front grille with your fingers.

The hood latch handle is above the ‘‘H’’ logo. Push this handle up until it releases the hood. Lift the hood.

If the hood latch handle moves stiffly, or if you can open the hood without lifting the handle, the mechanism should be cleaned and lubricated.

3. Holding the grip, pull the support

3. Holding the grip, pull the support rod out of its clip. Insert the end into the hole in the hood designated by an arrow.

To close the hood, lift it up slightly to remove the support rod from the hole. Put the support rod back into its holding clip. Lower the hood to about a foot (30 cm) above the fender, then let it drop. Make sure it is securely latched.

READ NEXT:

 Oil Check

Wait a few minutes after turning the engine off before you check the oil. 1. Remove the dipstick (orange handle). 2. Wipe off the dipstick with a clean cloth or paper towel. 3. Insert the d

 Engine Coolant Check

Look at the coolant level in the radiator reserve tank. Make sure it is between the MAX and MIN lines. If it is below the MIN line, see Adding Engine Coolant on page for information on add

 Fuel Economy

SEE MORE:

 DTC 28-3x ("x" can be 0 thru 9 or A thru F): Short to Another Wire or Decreased Resistance in Front Passenger's Seat Belt Buckle Tensioner

Special Tools Required SRS inflator simulator 07SAZ-TB4011A SRS simulator lead K 070AZ-SNAA200 NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for a

 Windshield Replacement

NOTE: Put on gloves to protect your hands. Wear eye protection when removing the glass with piano wire. Use seat covers to avoid damaging the seat. When replacing a broken windshield, a commercially available windshield cutter can be efficiently used for cutting the adhesive. Follow the equi

© 2016-2025 Copyright www.hcrv.net