Honda CR-V: TripMeter

This meter shows the number of miles (U.S.) or kilometers (Canada) driven since you last reset it.

There are two trip meters: Trip A and Trip B. Switch between these displays by pressing the select/reset knob repeatedly.

Each trip meter works independently, so you can keep track of two different distances.

When you turn the ignition switch to the ON (II) position, the last selection is displayed.

To reset a trip meter, display it, and then press and hold the select/reset knob until the number resets to ‘‘0.0’’.

READ NEXT:

 Instant Fuel Economy

This display shows the instant fuel economy you are getting. It shows the number of mpg (U.S.) or l/100 km (Canada).

 Average Fuel Economy

When either of the trip meters (trip A or B) is displayed, your vehicle’s average fuel economy since you last reset that tripmeter can be shown on the information display (mpg on U.S. mode

 Range (Estimated Distance)

This display shows the estimated distance you can travel on the fuel remaining in the tank. This distance is estimated from the fuel economy you have achieved over the last few miles (kilomet

SEE MORE:

 DTC Troubleshooting

DTC B1078: Daytime Running Lights Signal Error (Canada) DTC B1079: Daytime Running Lights Signal Error (USA) NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A. 1. Turn the ignition switch ON (II). 2. Pull the parking brake lever

 Rear Brake

Rear Brake Pad Inspection and Replacement Special Tools Required Brake caliper piston compressor 07AAE-SEPA101 CAUTION Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to -your health. Avoid breathing dust particles. Never use an air hose or brush to

© 2016-2025 Copyright www.hcrv.net