Honda CR-V: Break-in Period

Help assure your vehicle’s future reliability and performance by paying extra attention to how you drive during the first 600 miles (1,000 km).

During this period:

Avoid full-throttle starts and rapid acceleration.

Do not change the oil until the scheduled maintenance time.

Avoid hard braking for the first 200 miles (300 km).

Do not tow a trailer.

You should also follow these recommendations with an overhauled or exchanged engine, or when the brakes are replaced.

READ NEXT:

 Fuel Recommendation

Your vehicle is designed to operate on unleaded gasoline with a pump octane number of 87 or higher. Use of a lower octane gasoline can cause a persistent, heavy metallic rapping noise that c

 Service Station Procedures

 Refueling

1. Park with the driver’s side closest to the service station pump. 2. Open the fuel fill door by pulling on the handle located under the lower left corner of the dashboard. 3. Remove th

SEE MORE:

 Intake Manifold and Exhaust System

Intake Manifold Removal and Installation Exploded View Removal 1. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 2. Remove the bulkhead cover. 3. Disconnect the fan motor connectors (A) and hood switch connector (B), then remove the harness clips (C)

 Passenger's Tray Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. NOTE: Use the a

© 2016-2025 Copyright www.hcrv.net