Honda CR-V: Glass
Honda CR-V (2006–2011) Service Manual / Body / Glass
Component Location Index
- WINDSHIELD MOLDING
- MOLDING UPPER SEAL
- UPPER RUBBER DAM
- CLIP, 2
- WINDSHIELD SIDE TRIM
- SIDE RUBBER DAM
- WINDSHIELD
- RETAINER,8
- QUARTER GLASS MOLDING
- CLIP, 1
- CLIP, 2
- QUARTER GLASS
- ULEV STICKER
- FRONT SEAL
- UPPER RUBBER DAM
- UPPER FASTENER 2
- FASTENER 2
- LOWER FASTENER 2
- LOWER RUBBER DAM
- 4 WD STICKER
- REAR WINDOW
READ NEXT:
Windshield Replacement
NOTE:
Put on gloves to protect your hands.
Wear eye protection when removing the glass with
piano wire.
Use seat covers to avoid damaging the seat.
When replacing a broken windshield, a commerci
Rear Window Replacement
NOTE:
Put on gloves to protect your hands.
Wear eye protection when removing the glass with
piano wire.
Use seat covers to avoid damaging any surfaces.
Do not damage the rear window defogger gri
Quarter Glass Replacement
NOTE:
Put on gloves to protect your hands.
Wear eye protection when removing the glass with
piano wire.
Use seat covers to avoid damaging any surfaces.
The quarter glass molding will need replac
SEE MORE:
PGM-FI System
Component Location Index
CAMSHAFT POSITION (CMP)
SENSOR B (EXHAUST)
OUTPUT SHAFT (COUNTERSHAFT)
SPEED SENSOR
POWERTRAIN CONTROL
MODULE (PCM)
ELECTRICAL LOAD
DETECTOR (ELD)
(bottom of fuse/relay box)
A/F SENSOR
(LAF) RELAY
(RELAY SOCKET E)
IGNITION
CO
Brake System Indicator
The brake system indicator normally
comes on when you turn the ignition
switch to the ON (II) position, and as
a reminder to check the parking
brake. It will stay on if you do not
fully release the parking brake.
If the brake system indicator comes
on while driving, the brake fluid le
© 2016-2025 Copyright www.hcrv.net
