Honda CR-V: Compass Calibration
If you see ‘‘- -’’ in the direction display when you turn the ignition switch to the ON (II) position, the compass is self-calibrating.
The compass may need to be manually calibrated after exposure to a strong magnetic field. If the compass display changes to ‘‘- -’’ and the calibrate indicator blinks, or the display does not show any direction and the compass is not selfcalibrating, do the following.
1. Drive the vehicle slowly in three complete circles.
NOTE: Do this procedure in an open area, away from buildings, power lines, and other vehicles.
2. When the display goes from ‘‘- -’’ or blank to an actual heading, the unit is calibrated and the display returns to normal.
READ NEXT:
Compass Zone Selection
In most areas, there is a variation
between magnetic north and true
north. Zone selection is required so
the compass can compensate for this
variation. To check and select the
zone, do this:
Security System
If equipped
The security system helps to protect
your vehicle and valuables from theft.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights flash
Rearview Camera and Monitor
On EX-L model with navigation system
Whenever you shift to reverse (R)
with the ignition switch in the ON
(II) position, the rearview is shown
on the navigation system screen.
For the best p
SEE MORE:
Symptom Troubleshooting
No picture is displayed
NOTE: Always check the connectors for poor
connections or loose terminals between the audio unit,
audio disc changer, navigation unit, and XM receiver.
1. Check the No. 23 (10 A) fuse in the under-hood
fuse/relay box and No. 34 (7.S A) fuse in the under-dash
fuse/relay box, a
Rear Seat
Rear Seat Armrest Removal/Installation
NOTE: Take care not to tear the seams or damage the
seat covers.
1. Remove the E-ring (A) from the right side portion
on the armrest pivot.
2. Slide the armrest (A) toward the right side, then
release the left pivot shaft (B) from the bushing (C).
3. Release
© 2016-2025 Copyright www.hcrv.net
