Honda CR-V: Replacing a Parking Light/Front Side Marker Light Bulb

1. Open the hood.
To change the parking light/front
side marker on the driver’s side,
remove the fuse box fromits stay
by pulling out.

2. Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
3. Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
4. Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
5. Turn on the lights to make sure
the new bulb is working.
6. (Driver’s side)
Reinstall the fuse box in place
securely.
READ NEXT:
1. Open the tailgate. Place a cloth on
the edge of the cover to prevent
scratches. Remove the covers by
carefully prying on the edge with a
small flat-tip screwdriver.
2. Use a Phillips-h
1. Open the tailgate.
Unlatch the top of the cover by
pulling back on it with your hands.
2. Place a cloth on the side edge of
the cover to prevent scratches.
Remove the cover by carefully
Dirt build-up in the loops of the seat
belt anchors can cause the belts to
retract slowly. Wipe the insides of
the loops with a clean cloth
dampened in mild soap and warm
water or isopropy
SEE MORE:
1. Relieve fuel pressure.
2. Remove the engine cover.
3. Disconnect the connectors (A) from the injectors.
4. Remove the ground cable bolt (G101) (B).
5. Disconnect the quick-connect fitting (C).
6. Remove the fuel rail mounting nuts (D) from the fuel rail (E).
7. Remove the injector clip (F)
NOTE: Before you troubleshoot. record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Do the ETCS TEST in the INSPECTION MENU with
the HDS.
Is the RELAY circuit OK? YES-Intermittent failure, the system is OK a
© 2016-2025 Copyright www.hcrv.net
