Honda CR-V: Using the Cruise Control

1. Push the CRUISE button on the

1. Push the CRUISE button on the steering wheel. The CRUISE MAIN indicator on the instrument panel comes on.

The cruise control systemcan be left on, even when it is not in use.

2. Accelerate to the desired cruising speed above 25 mph (40 km/h).

3. Press and release the SET/ DECEL button on the steering wheel. The CRUISE CONTROL indicator on the instrument panel comes on to show the system is now activated.

Cruise control may not hold the set speed when you are going up and down hills. If your vehicle speed increases going down a hill, use the brakes to slow down. This will cancel the cruise control. To resume the set speed, press the RES/ACCEL button.

The CRUISE CONTROL indicator on the instrument panel will come back on.

READ NEXT:

 Changing the Set Speed

You can increase the set cruising speed in any of these ways: Press and hold the RES/ACCEL button. When you reach the desired cruising speed, release the button. To increase the speed in ver

 Canceling Cruise Control

You can cancel cruise control in any of these ways: Tap the brake pedal. Push the CANCEL button on the steering wheel. Push the CRUISE button on the steering wheel.

 Resuming the Set Speed

When you push the CANCEL button, or tap the brake pedal, the system remembers the previously set speed. To return to that speed, accelerate to above 25 mph (40 km/h), and then press and relea

SEE MORE:

 Carrying Cargo in the Cargo Area or on a Roof Rack

Distribute cargo evenly on the floor of the cargo area, placing the heaviest items on the bottom and as far forward as possible. Tie down items that could be thrown about the vehicle during a crash or sudden stop. Do not stack items higher than the back of the rear seats. They can b

 Self-diagnostic Function

Without Navigation The audio system has a self-diagnostic function. To run the self-diagnostic function, do the following: How to check for audio system condition NOTE: The audio unit must be in the code enter screen before doing the self-diagnostic function. 1. Turn the ignition switch to the AC

© 2016-2025 Copyright www.hcrv.net