Honda CR-V: Replacing Tires andWheels

Replace your tires with radial tires of the same size, load range, speed rating, and maximum cold tire pressure rating (as shown on the tire’s sidewall).

Mixing radial and bias-ply tires on your vehicle can reduce braking ability, traction, and steering accuracy. Using tires of a different size or construction can cause the ABS and vehicle stability assist system (VSA) to work inconsistently.

The ABS and VSA system work by comparing the speed of each wheel.

When replacing tires, use the same size originally supplied with the vehicle. Tire size and construction can affect wheel speed and may cause the system to activate.

It is best to replace all four tires at the same time. If that is not possible or necessary, replace the two front tires or two rear tires as a pair.

Replacing just one tire can seriously affect your vehicle’s handling.

If you ever replace a wheel, make sure that the wheel’s specifications match those of the original wheels.

Also be sure you use only TPMS specific wheels. If you do not, the tire pressure monitoring system will not work on that tire.

Replacement wheels are available at your dealer.

Installing improper tires on your

Installing improper tires on your vehicle can affect handling and stability. This can cause a crash in which you can be seriously hurt or killed.

Always use the size and type of tires recommended in this owner’s manual.

READ NEXT:

 Wheel and Tire Specifications

Wheels: 17 x 6 1/2J Tires: 225/65R17 102T

 Winter Driving

Tires marked ‘‘M + S’’ or ‘‘All Season’’ on the sidewall have an allweather tread design suitable for most winter driving conditions. For the best performance in snowy or icy

 Wheels

Clean the wheels as you would the rest of the exterior. Wash them with the same solution, and rinse them thoroughly. If equipped Aluminum alloy wheels have a protective clear-coat that keeps

SEE MORE:

 DTC 31-3x ("x" can be 0 thru 9 or A thru F): Short to Another Wire or Decreased Resistance in Driver's Side Airbag Inflator

Special Tools Required SRS inflator simulator 07SAZ-TB4011A SRS simulator lead L 070AZ-SNAA300 SRS short canceller 070AZ-SAA0100 NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Turn the ignition switch ON (II), and check t

 DTC P0300: Random Misfire and Any Combination of the Following

DTC P0301: No.1 Cylinder Misfire Detected DTC P0302: No.2 Cylinder Misfire Detected DTC P0303: No.3 Cylinder Misfire Detected DTC P0304: No.4 Cylinder Misfire Detected Special Tools Required Pressure gauge adapter 07NAJ-P07010A A/T low pressure gauge w/panel 07406-0070301 A/T pressure hose 07406

© 2016-2025 Copyright www.hcrv.net