Honda CR-V: Floor Mats

The floor mats that came with your

The floor mats that came with your vehicle hook over the floor mat anchors. This keeps the floor mats from sliding forward, possibly interfering with the pedals, or backwards, making the front passenger’s weight sensors ineffective.

If you remove a floor mat, make sure to re-anchor it when you put it back in your vehicle.

If you use a non-Honda floor mat, make sure it fits properly and that it can be used with the floormat anchors. Do not put additional floor mats on top of the anchored mats.

READ NEXT:

 Audio Antenna

Your vehicle is equipped with an antenna at the rear of the roof . Bef ore using a ‘‘drive-through’’ car wash, remove the antenna by unscrewing it by hand. This prevents the antenna

 Dust and Pollen Filter

This filter removes the dust and pollen that is brought in fromthe outside through the heating and cooling system/climate control system. Have your dealer replace this filter when this serv

 Wiper Blades

Check the condition of the wiper blades at least every six months. Replace them if you find signs of cracking in the rubber, areas that are getting hard, or if they leave streaks and unwiped

SEE MORE:

 Horns

Component Location Index HORN HORN SWITCH HORN RELAY CIRCUIT (Built into the MICU) CABLE REEL UNDER-DASH FUSE/RELAY BOX Circuit Diagram Horn Switch Test 1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 20P connector (A) from the cable reel (B). 3. Usin

 Steering Column

Steering Column Removal and Installation SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. Removal NOTICE Be careful not to pull the bracket (A) on the front side of steering column out of its normal positi

© 2016-2025 Copyright www.hcrv.net