Honda CR-V: Differential Mount Replacement

Exploded View

Honda CR-V. Rear Differential

Differential Installation

1. Install rear differential mount assembly A to the rear differential assembly (B).

Honda CR-V. Rear Differential

2. Jack up the rear differential.

3. Install the new set rings (A) onto the driveshafts, then insert the drives hafts into the rear differential.

Honda CR-V. Rear Differential

4. Lift the rear differential up into position, then push on both driveshafts to lock the set rings into place.

Connect the breather tube (B).

5. Align the tab (A) of the rubber mount (B) with the hole (C) of the plates (D), then install the plates and torque the rear differential mount assembly mounting bolts (E).

NOTE: The rubber heat insulator (F) is installed only in the right side.

Honda CR-V. Rear Differential

6. Install the breather tubes (G) to the clips (H).

7. Install the right and left rear differential mount brackets B (A), then torque the bolts (B).

Honda CR-V. Rear Differential

8. Install the breather tube (C) to the clip (D).

9. Install the No.2 propeller shaft (A) onto the rear differential (B) by aligning the reference marks (C) made during removal. Make sure you use new mounting bolts (D).

Honda CR-V. Rear Differential

10. Fill the rear differential with the differential fluid to the proper level.

READ NEXT:

 Driveline/Axle

Special Tools Oil Seal Driver Attachment, 52 x 55 mm Half Shaft Base Threaded Adapter, 24 x 1.5 mm Threaded Adapter, 26 x 1.5 mm Attachment, 35 mm I.D. Driver Inner Handle, 30 mm Oil Seal

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2.

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remov

SEE MORE:

 Operating the XM Radio

To listen to XM radio, turn the ignition switch to the ACCESSORY (I) or the ON (II) position. Push the button to turn on the audio system, and press the ‘‘XM’’ button. Adjust the volume by turning the VOL/SELECT knob. The last channel you listened to will show in the display.

 Center Table

On LX and EX models To use the center table, pull up the outside edge of the table until it latches. To store it, pull the lever and lower the table. Sitting on or getting under the table, or putting heavy objects on the table, may damage or deform it. Do not put any items on th

© 2016-2025 Copyright www.hcrv.net