Honda CR-V: Detachable Anchor

The seat belt in the rear center seat is equipped with a detachable anchor.

This allows the center seat belt to be unlatched when the rear center seat back is folded down or the right side rear seat is folded forward.

Using the seat belt with the

Using the seat belt with the detachable anchor unlatched increases the chance of serious injury or death in a crash.

Before using the seat belt, make sure the detachable anchor is correctly latched.

Pull out the small latch plate and the

Pull out the small latch plate and the latch plate from each holding slot in the ceiling, and pull out the seat belt to extend it.

Line up the triangle marks on the

Line up the triangle marks on the small latch plate and anchor buckle when reattaching the belt and buckle.

Tug on the seat belt to verify that the detachable anchor is securely latched. Make sure the seat belt is not twisted.

To unlatch the detachable anchor,

To unlatch the detachable anchor, insert the latch plate into the slot on the side of the anchor buckle. Store the detachable anchor and seat belt latch plates in the retractor housing.

READ NEXT:

 Seat Heaters

If equipped Both front seats are equipped with seat heaters. The passenger seat only has heaters in the seat bottom because of the side airbag cutoff system. The ignition switch must

 Power Windows

Turn the ignition switch to the ON (II) position to raise or lower any window. To open the window, push the switch down and hold it. Release the switch when you want to stop the window.

 Moonroof

If equipped The moonroof can be tilted up in the back for ventilation, or it can be slid back into the roof. Use the switch on the front ceiling to operate the moonroof. You must turn the

SEE MORE:

 Dehumidify the Interior

Air conditioning, as it cools, removes moisture from the air.When used in combination with the heater, it makes the interior warm and dry and can prevent the windows from fogging up. 1. Turn the fan on. 2. Turn on the air conditioning. 3. Select and fresh air mode. 4. Adjust the temp

 MICU Input Test

NOTE: The MICU turns on the headlights (high beams) in a dim mode for the daytime running lights under the following conditions: The ignition switch is ON (II) The headlight switch is OFF The parking brake is released (parking brake switch OFF) If the vehicle is equipped with an opti

© 2016-2025 Copyright www.hcrv.net