Honda CR-V: Dehumidify the Interior

Air conditioning, as it cools, removes moisture from the air.When used in combination with the heater, it makes the interior warm and dry and can prevent the windows from fogging up.

1. Turn the fan on.

2. Turn on the air conditioning.

3. Select 4. Adjust the temperature to your and fresh air mode.

4. Adjust the temperature to your preference.

This setting is suitable for all driving conditions whenever the outside temperature is above 32°F (0°C).

READ NEXT:

 To Defog and Defrost

To remove fog from the inside of the windows: 1. Set the fan to the desired speed, or high for faster defrosting. 2. Select . The system automatically switches to fresh air mode and turns o

 To Remove Exterior Frost or Ice Fromthe Windows

1. Select . The system automatically switches to fresh air mode and turns on the A/C. The A/C indicator does not come on if it was off to start with. 2. Select . 3. Set the fan and temperat

 To Turn Everything Off

Turning the fan speed control dial all the way to the left shuts the system off. Keep the system off for short periods only. To keep stale air and mustiness from collecting, you should have

SEE MORE:

 Lower Ball Joint Replacement

Special Tools Required Ball joint remover, 32 mm 07MAC-SL0A 102 Ball joint thread protector, 14 mm 071AF-S3VA000 1. Remove the front wheel. 2. Remove the flange bolt and flange nuts from the lower arm (A). NOTE: During installation, install a new flange bolt and new flange nuts. After lightly

 Door Lock

Door Lock Actuator Test Driver's Door and Left Rear Door 1. Remove the door panel. Front Rear 2. Disconnect the 10P connector (A) from the actuator (B). NOTE: The illustration shows the driver's door. 3. Check the actuator operation by connecting power and ground according to the table. To

© 2016-2025 Copyright www.hcrv.net