Honda CR-V: Cruise Control
Component Location Index
- CRUISE MAIN INDICATOR
- CRUISE CONTROL INDICATOR
- CRUISE CONTROL
COMBINATION SWITCH
- BRAKE PEDAL POSITION SWITCH

Symptom Troubleshooting
Index


Circuit Diagram

Cruise Control Input Test
1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC)
(see step 2).
2. Turn the ignition switch ON (II).
3. Make sure the HDS communicates with the vehicle and the powertrain control
module (PCM). If it doesn't,
troubleshoot the DLC circuit.
4. Go to PGM-FI, and check for DTCs.
5. Do the following tests while monitoring parameters in the PGM-FI DATA LIST
with the HDS.
NOTE: Intermittent failures are often caused by loose circuit connections. While
monitoring cruise control inputs,
flex their circuits, and note if any of the test results change.


Cruise Control Combination
Switch Test/Replacement
SRS components are located in this area. Review the
SRS component locations and the
precautions and procedures before
doing repairs or service.
1. Remove the steering wheel.
2. Remove the screws (A). Disconnect the 12P
connector (B), then remove the cruise control
combination switch.

3. Check for continuity between the terminals in each
switch position according to the table.
- If there is continuity, and it matches the table, but
switch failure occurred on the cruise control
input test, check and repair the wire harness on
the switch circuit.
- If there is no continuity in one or more positions,
replace the switch.


4. Check for continuity between the terminals in
according to the table.
- If there is continuity, and it matches the table,
check and repair the wire harness on the switch
circuit.
- If there is no continuity in one or more positions,
replace the switch.

Engine Electrical
Special Tools


-
Attachment, 42 x 47 mm
-
Driver
READ NEXT:
Universal eyelet 07AAK-SNAA120
Engine hanger adapter VSB02C000015 *
Front subframe adapter VSB02C000016 *
CR-V engine hanger adapter VSB02C000032 *
Engine support hanger, A and Reds AAR-T-12566
SEE MORE:
Each time you press the TITLE
button, the display shows you the
text, if the disc was recorded with
text data.
You can see the album, artist, and
track name in the display. If a disc is
recorded in MP3 or WMA, you can
see the folder and file name, and the
artist, album, and track tag.
CAUTION
Do not insert your fingers into the installed throttle
body when you turn the ignition switch ON (II) or
while the ignition switch is ON (II). If you do, you
will seriously injure your fingers if the throttle valve
is activated.
NOTE: Before you troubleshoot, record all freeze data and any o
© 2016-2025 Copyright www.hcrv.net
