Honda CR-V: Side Engine Mount Bracket Replacement

1. Support the engine with a jack and wood block under the oil pan.

2. Remove the upper torque rod.

Honda CR-V. Side Engine Mount Bracket Replacement

3. Remove the ground cable (A), then remove the side engine mount bracket (B).

Honda CR-V. Side Engine Mount Bracket Replacement

4. Install the side engine mount bracket, then loosely tighten the new bolt and nut (C), and loosely tighten the bolt (D).

5. Install the ground cable.

6. Remove the air cleaner housing assembly.

7. Loosen the transmission mounting bolt and nuts (A).

Honda CR-V. Side Engine Mount Bracket Replacement

8. Raise the lift to full height.

9. Loosen the lower torque rod mounting bolt (A).

Honda CR-V. Side Engine Mount Bracket Replacement

10. Lower the vehicle on the lift.

11. Tighten the side engine mount mounting bolts and nut.

Honda CR-V. Side Engine Mount Bracket Replacement

12. Tighten the transmission mounting bolt and nuts.

Honda CR-V. Side Engine Mount Bracket Replacement

13. Raise the lift to full height.

14. Tighten the lower torque rod mounting bolt.

Honda CR-V. Side Engine Mount Bracket Replacement

15. Lower the vehicle on the lift.

16. Install the air cleaner housing assembly.

17. Install the upper torque rod, then tighten the new upper torque rod mounting bolts in the numbered sequence shown.

Honda CR-V. Side Engine Mount Bracket Replacement

 

Engine Assembly

Special Tools

Honda CR-V. Special Tools

Honda CR-V. Special Tools

READ NEXT:

 Cylinder Head

Special Tools Air Pressure Regulator Valve Guide Reamer, 5.5 mm Socket, 19 mm Holder Handle Adjuster Locknut Wrench Stem Seal Driver VTEC Air Adapter VTEC Air Stopper Air Joint Adapter C

 Engine Compression Inspection

NOTE: After this inspection, you must reset the powertrain control module (PCM), otherwise the PCM will continue to stop the injectors from functioning. Select PCM reset using the Honda Diagnostic Sy

 Valve Clearance Adjustment

Special Tools Required Adjuster 07MAA-PR70110 Locknut wrench 07MAA-PR70120 NOTE: Adjust the valves only when the cylinder head temperature is less than 100 ºF (38 ºC). 1. Remove the cylinder hea

SEE MORE:

 To Change or Select Tracks/Files

You can use the SEEK button while a disc is playing to change tracks (files in MP3/WMA mode). In MP3/WMA mode, use the or button to select folders in the disc, and use the SEEK button to change files. SEEK/SKIP - Each time you press and release the side, the player skips forwa

 Seat Heaters

Component Location Index DRIVER'S SEAT HEATER RELAY (HIGH) DRIVER'S SEAT HEATER RELAY (LOW) DRIVER'S SEAT CUSHION HEATER DRIVER'S SEAT-BACK HEATER FRONT PASSENGER'S SEAT-BACK HEATER FRONT PASSENGER'S SEAT CUSHION HEATER FRONT PASSENGER'S SEAT HEATER RELAY (HIGH) FRONT PASSENGER'S SE

© 2016-2025 Copyright www.hcrv.net