Honda CR-V: Adjusting the Sound
Press the SOUND (TUNE) knob repeatedly to display the BASS, TREBLE, FADER, BALANCE, and SVC (speed-sensitive volume compensation) settings.
BASS - Adjusts the bass.
TREBLE - Adjusts the treble.
FADER - Adjusts the front-to-back strength of the sound.
BALANCE - Adjusts the side-toside strength of the sound.
SVC - Adjusts the volume level based on the vehicle speed.
Eachmode is shown in the display as it changes. Turn the TUNE knob to adjust the setting to your liking.
When the level reaches the center, you will see ‘‘C’’ in the display.
Except SVC adjustment
The system will return to the audio display about 5 seconds after you stop adjusting a mode.
Speed-sensitive Volume Compensation (SVC)
The SVC mode controls the volume based on vehicle speed. The faster you go, the louder the audio volume becomes. As you slow down, the audio volume decreases.
The SVC has four modes: SVC OFF, SVC LOW, SVC MID, and SVC HIGH. Turn the TUNE knob to adjust the setting to your liking. If you feel the sound is too loud, choose low. If you feel the sound is too quiet, choose high.
This function is set to MID as the default setting when the vehicle leaves the factory.
READ NEXT:
Audio System Lighting
You can use the instrument panel
brightness control knob to adjust the
illumination of the audio system. The audio system
illuminates when the parking lights
are on, even if the radio is turne
Playing a Disc (LX model)
Playing a Disc (LX model)
To Play a Disc
To load or play a disc, the ignition
switch must be in the ACCESSORY
(I) or ON (II) position.
You operate the disc player with the
same controls used for the radio. To
select the disc player,
SEE MORE:
Cam Chain Installation
NOTE:
Keep the cam chain away from magnetic fields.
Before this procedure, check that the variable valve
timing control (VTC) actuator is locked by turning the
VTC actuator counterclockwise. If not locked, turn the
VTC actuator clockwise until it stops, then recheck it.
If it is still not loc
Shafts and Clutches
Mainshaft Disassembly, Inspection, and Reassembly
1. Inspect the thrust needle bearing and the needle bearing for galling and
rough movement.
2. Inspect the splines for excessive wear and damage.
3. Check shaft bearing surface for scoring and excessive wear.
4. Before installing the O-rings, wra
