Honda CR-V: Fan, Fan Motor, Shroud Removal and Installation
Removal
1. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position.
2. Remove the bulkhead cover.
3. Disconnect the fan motor connectors (A) and hood switch connector (B), then remove the harness clips (C).
4. Remove the radiator upper brackets (A), then remove the front bulkhead (B).
5. Remove the condenser fan shroud assembly (A), then remove the radiator fan shroud assembly (B) from condenser fan shroud side.
6. Disassemble the fan shrouds.
Installation
1. Assemble the fan shrouds.
2. Install the radiator fan shroud assembly (A), then install the condenser fan shroud assembly (B).
3. Install the front bulkhead (A), then install the radiator upper brackets (B).
4. Apply body paint to the bulkhead mounting bolts.
5. Connect the fan motor connectors (A) and hood switch connector (B), then install the harness clips (C).
6. Remove the bulkhead cover.
READ NEXT:
Radiator Replacement
For Japan-produced Model
1. Drain the engine coolant.
2. Remove the hood support rod, then use it as shown
to prop the hood in the wide-open position.
3. Remove the bulkhead cover.
4. Remove the co
Fan Controls
Component Location Index
RADIATOR FAN RELAY
A/C CONDENSER FAN RELAY
FAN CONTROL RELAY
A/C CONDENSER FAN ASSEMBLY
RADIATOR FAN ASSEMBLY
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 1
E
SEE MORE:
To Select a Station
You can use any of five methods to
find radio stations on the selected
band: tune, seek, scan, the preset
buttons, and auto select.
TUNE - Use the SEEK button to
tune to a desired frequency. Press
the
button to tune to a higher
frequency, and the button to
tune to a lower frequency
Drive Belt Inspection
1. Inspect the belt for cracks and damage. If the belt is
cracked or damaged, replace it.
2. Check that the auto-tensioner indicator (A) is within
the standard range (B) as shown. If it is out of the
standard range, replace the drive belt.
Drive Belt Removal/Installation
Special Tools Required
Bel
