Honda CR-V: Compass Calibration

If you see ‘‘- -’’ in the direction

If you see ‘‘- -’’ in the direction display when you turn the ignition switch to the ON (II) position, the compass is self-calibrating.

The compass may need to be manually calibrated after exposure to a strong magnetic field. If the compass display changes to ‘‘- -’’ and the calibrate indicator blinks, or the display does not show any direction and the compass is not selfcalibrating, do the following.

1. Drive the vehicle slowly in three complete circles.

NOTE: Do this procedure in an open area, away from buildings, power lines, and other vehicles.

2. When the display goes from ‘‘- -’’ or blank to an actual heading, the unit is calibrated and the display returns to normal.

READ NEXT:

 Compass Zone Selection

In most areas, there is a variation between magnetic north and true north. Zone selection is required so the compass can compensate for this variation. To check and select the zone, do this:

 Security System

If equipped The security system helps to protect your vehicle and valuables from theft. The horn sounds and a combination of headlights, parking lights, side marker lights and taillights flash

 Rearview Camera and Monitor

On EX-L model with navigation system Whenever you shift to reverse (R) with the ignition switch in the ON (II) position, the rearview is shown on the navigation system screen. For the best p

SEE MORE:

 DTC P0716: Problem in Input Shaft (Mainshaft) Speed Sensor Circuit

DTC P0716: Problem in Input Shaft (Mainshaft) Speed Sensor Circuit DTC P0717: Problem in Input Shaft (Mainshaft) Speed Sensor Circuit (No Signal Input) NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is c

 Side Engine Mount Replacement

1. Support the engine with a jack and wood block under the oil pan. 2. Remove the power steering (P/S) fluid reservoir from the holder. 3. Remove the upper torque rod. 4. Remove the ground cable (A), then remove the side engine mount bracket (B). 5. Remove the side engine mount stiffener (A), th

© 2016-2025 Copyright www.hcrv.net