Honda CR-V: Additional Information on Recommended Discs

Honda CR-V (2006–2011) Owner's Manual / Features / Protecting Your Discs / Additional Information on Recommended Discs

The disc player/changer has a sophisticated and delicate mechanism. If you insert a damaged disc as indicated in this section, it may become stuck inside and damage the audio unit.

Examples of these discs are shown to the right:

1. Bubbled, wrinkled, labeled, and excessively thick discs

1. Bubbled, wrinkled, labeled, and excessively thick discs

2. Damaged discs

2. Damaged discs

3. Poor quality discs

3. Poor quality discs

4. Small, irregular shaped discs

4. Small, irregular shaped discs

5. Discs with scratches, dirty discs

5. Discs with scratches, dirty discs

CD-R or CD-RW may not play due to the recording conditions.

Scratches and fingerprints on the discs may cause the sound to skip.

Recommended discs are printed

Recommended discs are printed with the following logo.

Audio unit may not play the

Audio unit may not play the following formats.

READ NEXT:

 Remote Audio Controls

If equipped Three controls for the audio system are mounted in the steering wheel hub. These let you control basic functions without removing your hand from the wheel. The VOL button adjus

 Playing an Optional Audio Unit

Your vehicle has the auxiliary input jack on the front panel, on the center table, or in the console compartment, depending on models. The system will accept auxiliary input from standard

 Radio Theft Protection

Your vehicle’s audio system will disable itself if it is disconnected from electrical power for any reason. To make it work again, you must enter a specific code using the preset buttons (i

SEE MORE:

 Door Lock

Door Lock Actuator Test Driver's Door and Left Rear Door 1. Remove the door panel. Front Rear 2. Disconnect the 10P connector (A) from the actuator (B). NOTE: The illustration shows the driver's door. 3. Check the actuator operation by connecting power and ground according to the table. To

 Rear Bumper

Rear Bumper Removal/Installation NOTE: Have an assistant help you when removing and installing the rear bumper. Take care not to scratch the rear bumper and body. Put on gloves to protect your hands. 1. Remove the rear splash guard. 2. Remove the caps (A). Remove the bolts (B, C) and clips (D

© 2016-2025 Copyright www.hcrv.net