Honda CR-V: Turn Signal/Hazard Flasher
Component Location Index

- TURN SIGNAL SWITCH
(Built into the combination light switch)
- TURN SIGNAL INDICATORS
- HAZARD WARNING SWITCH
- MICU (Built into the under-dash fuse/relay box)
Circuit Diagram


MICU Input Test
NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A.
1. Check the No. 10 (7.5 A) fuse in the under-dash fuse/relay box. lf the fuse
is blown, replace it and go to step 2.
2. Disconnect the under-dash fuse/relay box connectors E, F, G, P, Q, R, S, and
T.
NOTE: All connector views are wire side of female terminals.


3. Inspect the connector and socket terminals to be sure they are all making
good contact.
- If the terminals are bent, loose or corroded, repair them as necessary
and recheck the system.
- If the terminals look OK, go to step 4.
4. With the connectors still disconnected, make these input tests at the
appropriate connector.
- If any test indicates a problem, find and correct the cause, then
recheck the system.
- If all the input tests prove OK, go to step 5.

5. Reconnect the connectors to the under-dash fuse/relay box, and make these
input tests at the connectors.
- If any test indicates a problem, find and correct the cause, then
recheck the system.
- If all the input tests prove OK, the MICU must be faulty; replace the
under-dash fuse/relay box.

Hazard Warning Switch
Test/Replacement
1. Remove the center vent.
2. Remove the hazard warning switch (A).

3. Check for continuity between the terminals in each
switch position according to the table.

4. If the continuity is not as specified, replace the
hazard warning switch.
READ NEXT:
Component Location Index
With moon roof
INDIVIDUAL MAP LIGHTS
INTERIOR LIGHT SWITCH
(Built into the moonroof switch)
AMBIENT LIGHT
(Built into the moonroof switch)
CEILING LIGHT
CARGO AREA LI
Component Location Index
With moonroof
INDIVIDUAL MAP LIGHTS
IGNITION KEY SWITCH
IGNITION KEY LIGHT
CEILING LIGHT
CARGO AREA LIGHT
RIGHT REAR DOOR SWITCH
FRONT PASSENGER'S
DOOR SWITCH
LEFT
Component Location Index
POWER WINDOW MASTER SWITCH
(With built-in control unit)
FRONT PASSENGER'S POWER WINDOW SWITCH
FRONT PASSENGER'S POWER WINDOW MOTOR
RIGHT REAR POWER WINDOW SWITCH
RIGHT
SEE MORE:
Your vehicle has a back seat where
children can be properly restrained.
If you ever have to carry a group of
children, and a child must ride in
front:
Place the largest child in the front
seat, provided the child is large
enough to wear the lap/shoulder
belt properly.
Move the vehicle
Electronic Control System
The functions of the fuel and emission control systems are managed by the
powertrain control module (PCM).
Self-diagnosis
The PCM detects a failure of a signal from a sensor or from another control
unit and stores a Temporary DTC or a DTC.
Depending on the failure, a DTC
© 2016-2025 Copyright www.hcrv.net
