Honda CR-V: To Remove Exterior Frost or Ice Fromthe Windows
Honda CR-V (2006–2011) Owner's Manual / Features / Vents, Heating, and A/C / To Remove Exterior Frost or Ice Fromthe Windows
1. Select
. The system
automatically switches to fresh air
mode and turns on the A/C.
The A/C indicator does not come on if it was off to start with.
2. Select
.
3. Set the fan and temperature controls to maximum level.
To clear the windows faster, you can close the dashboard corner vents by rotating the wheel below each vent.
This sends more warm air to the windshield defroster vents. Once the windshield is clear, select fresh air mode to avoid fogging the windows.
For your safety, make sure you have a clear view through all the windows before driving.
READ NEXT:
To Turn Everything Off
Turning the fan speed control dial all
the way to the left shuts the system
off.
Keep the system off for short
periods only.
To keep stale air and mustiness
from collecting, you should have
Climate Control System
Climate Control System
Voice Control System
On vehicles with navigation system
The climate control system for your
vehicle can also be operated using
the voice control system. See the
navigation system manual for
complete details.
SEE MORE:
Operating the XM Radio
To listen to XM radio, turn the
ignition switch to the ACCESSORY
(I) or the ON (II) position. Push the
button to turn on the audio
system, and press the ‘‘XM’’ button.
Adjust the volume by turning the
VOL/SELECT knob. The last
channel you listened to will show in
the display.
Boot Band Installation
Special Tools Required
Boot band tool, KD-3191 or equivalent, commercially
available
Boot band pliers, Kent-Moore J-35910 or equivalent,
commercially available
Double Loop Type
1. Fit the boot ends onto the driveshaft and the
inboard joint, then install the new double loop band
(A) onto the boot.
N
© 2016-2025 Copyright www.hcrv.net
