Honda CR-V: Fan, Fan Motor, Shroud Removal and Installation
Removal
1. Remove the hood support rod, then use it as shown
to prop the hood in the wide-open position.

2. Remove the bulkhead cover.
3. Disconnect the fan motor connectors (A) and hood
switch connector (B), then remove the harness clips
(C).

4. Remove the radiator upper brackets (A), then
remove the front bulkhead (B).

5. Remove the condenser fan shroud assembly (A),
then remove the radiator fan shroud assembly (B)
from condenser fan shroud side.

6. Disassemble the fan shrouds.

Installation
1. Assemble the fan shrouds.

2. Install the radiator fan shroud assembly (A), then
install the condenser fan shroud assembly (B).

3. Install the front bulkhead (A), then install the
radiator upper brackets (B).

4. Apply body paint to the bulkhead mounting bolts.
5. Connect the fan motor connectors (A) and hood
switch connector (B), then install the harness clips
(C).

6. Remove the bulkhead cover.
READ NEXT:
For Japan-produced Model
1. Drain the engine coolant.
2. Remove the hood support rod, then use it as shown
to prop the hood in the wide-open position.
3. Remove the bulkhead cover.
4. Remove the co
Component Location Index
RADIATOR FAN RELAY
A/C CONDENSER FAN RELAY
FAN CONTROL RELAY
A/C CONDENSER FAN ASSEMBLY
RADIATOR FAN ASSEMBLY
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 1
E
SEE MORE:
1. Support the engine with a jack and wood block
under the oil pan.
2. Remove the power steering (P/S) fluid reservoir
from the holder.
3. Remove the upper torque rod.
4. Remove the ground cable (A), then remove the side
engine mount bracket (B).
5. Remove the side engine mount stiffener (A), th
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the same time as DTC P0101, troubleshoot those
DTCs first, then recheck for DTC P0101.
1. Check for poor
© 2016-2025 Copyright www.hcrv.net
