Honda CR-V: Rear Seat Adjustments
To adjust the seats forward and backward, pull up on the lever under the seat cushion. After moving the seat, make sure it is locked into position.
The angle of each rear seat-back can be adjusted separately. To change the seat-back angle of the rear seatback, pull up on the release lever on the top of the seat-back.Move the seat-back to the desired position, then release the lever. Make sure the seat-back latches in the new position.
When using the center seating position, adjust the left and right side of the rear seats to the same position.
Make sure all rear shoulder belts are positioned in front of the rear seatbacks after you adjust the rear seats.
READ NEXT:
Armrests
Each front seat has an armrest on
the side of the seat-back. To use it,
pivot it down.
The rear seat armrest is in the
center of the rear seat. Pivot it down
to use it.
Cargo Pass-through
The rear center seat-back has a
cargo area pass-through. To use the
cargo area pass-through, pull up the
release on top of the center seatback
and fold it down.
If your vehicle is equippe
Head Restraints
See page for important safety
information and a warning about
improperly positioning head restraints.
Your vehicle is equipped with head
restraints in all seating positions to
help protect yo
SEE MORE:
DTC P0010: VTC Oil Control Solenoid Valve
Malfunction
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine. Hold the engine speed at
3,000 rpm without load (in Park or neutral) until
Symptom Troubleshooting
SRS indicator does not come on
1. Connect the HDS to the DLC.
2. Turn the ignition switch ON (II).
3. Make sure the HDS communicates with the vehicle and the SRS unit. If it does
not communicate, troubleshoot the DLC circuit.
4. Check for PGM-FI, Body Electrical, and SRS DTCs
with the HDS.
Are
© 2016-2025 Copyright www.hcrv.net
