Honda CR-V: Floor Mats

The floor mats that came with your

The floor mats that came with your vehicle hook over the floor mat anchors. This keeps the floor mats from sliding forward, possibly interfering with the pedals, or backwards, making the front passenger’s weight sensors ineffective.

If you remove a floor mat, make sure to re-anchor it when you put it back in your vehicle.

If you use a non-Honda floor mat, make sure it fits properly and that it can be used with the floormat anchors. Do not put additional floor mats on top of the anchored mats.

READ NEXT:

 Audio Antenna

Your vehicle is equipped with an antenna at the rear of the roof . Bef ore using a ‘‘drive-through’’ car wash, remove the antenna by unscrewing it by hand. This prevents the antenna

 Dust and Pollen Filter

This filter removes the dust and pollen that is brought in fromthe outside through the heating and cooling system/climate control system. Have your dealer replace this filter when this serv

 Wiper Blades

Check the condition of the wiper blades at least every six months. Replace them if you find signs of cracking in the rubber, areas that are getting hard, or if they leave streaks and unwiped

SEE MORE:

 Entry Lights Control System

Component Location Index With moonroof INDIVIDUAL MAP LIGHTS IGNITION KEY SWITCH IGNITION KEY LIGHT CEILING LIGHT CARGO AREA LIGHT RIGHT REAR DOOR SWITCH FRONT PASSENGER'S DOOR SWITCH LEFT REAR DOOR SWITCH DRIVER'S DOOR SWITCH DRIVER'S DOOR LOCK KNOB SWITCH MICU (Built into the under

 DTC 51: Motor Locked

1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Test-drive the vehicle. Drive the vehicle at 10 mph (15 km/h) or more, with the engine speed at 2,500 rpm or more. 4. Check for DTCs with the HDS. Is DTC 51 indicated? YES-Replace the VSA modulator-control unit. NO-Intermitt

© 2016-2025 Copyright www.hcrv.net