Honda CR-V: Compass Zone Selection
In most areas, there is a variation between magnetic north and true north. Zone selection is required so the compass can compensate for this variation. To check and select the zone, do this:
1. Press and hold the select/reset knob for 10 seconds to change the display to the reset mode.
2. Select the zone indicator by turning the select/reset knob. The display begins to blink. Push the same knob to enter this setting.
3. Find the zone for your area on the zone map. Each zone number (1 through 15) corresponds to a compass zone.
4. Turn the select/reset knob to select the appropriate zone number, and press the select/ reset knob to enter the number.
When the system does not accept the selected compass zone, you see ‘‘- -’’ in the direction display. Select appropriate zone number again.
READ NEXT:
Security System
If equipped
The security system helps to protect
your vehicle and valuables from theft.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights flash
Rearview Camera and Monitor
On EX-L model with navigation system
Whenever you shift to reverse (R)
with the ignition switch in the ON
(II) position, the rearview is shown
on the navigation system screen.
For the best p
Cruise Control
Cruise control allows you to maintain
a set speed above 25 mph (40 km/h)
without keeping your foot on the
accelerator pedal. It should be used
for cruising on straight, open
highways. It is
SEE MORE:
DTC Troubleshooting
DTC B1028: Rear Window Wiper Motor (As)
Signal Error
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN System
Diagnosis Test Mode A.
1. Clear the DTCs with the HDS.
2. Turn the. ignition switch OFF, and then back ON (II).
3. Operate the rear window wiper f
Moonroof
Component Location Index
GLASS
DRAIN CHANNEL
SUNSHADE
CABLE ASSEMBLY
CABLE TUBE
REAR BRACKET
MOTOR
WIND DEFLECTOR
REAR DRAIN TUBE
REAR DRAIN VALVE
FRAME
CLIP
FRONT DRAIN VALVE
FRONT DRAIN TUBE
Symptom Troubleshooting Index
Glass Position Adjustment
The roof panel (A) should be ev
