Honda CR-V: Rear Seat Adjustments
To adjust the seats forward and backward, pull up on the lever under the seat cushion. After moving the seat, make sure it is locked into position.
The angle of each rear seat-back can be adjusted separately. To change the seat-back angle of the rear seatback, pull up on the release lever on the top of the seat-back.Move the seat-back to the desired position, then release the lever. Make sure the seat-back latches in the new position.
When using the center seating position, adjust the left and right side of the rear seats to the same position.
Make sure all rear shoulder belts are positioned in front of the rear seatbacks after you adjust the rear seats.
READ NEXT:
Armrests
Each front seat has an armrest on
the side of the seat-back. To use it,
pivot it down.
The rear seat armrest is in the
center of the rear seat. Pivot it down
to use it.
Cargo Pass-through
The rear center seat-back has a
cargo area pass-through. To use the
cargo area pass-through, pull up the
release on top of the center seatback
and fold it down.
If your vehicle is equippe
Head Restraints
See page for important safety
information and a warning about
improperly positioning head restraints.
Your vehicle is equipped with head
restraints in all seating positions to
help protect yo
SEE MORE:
DTC P1658: ETCS Control Relay ON
Malfunction
NOTE: Before you troubleshoot. record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Do the ETCS TEST in the INSPECTION MENU with
the HDS.
Is the RELAY circuit OK? YES-Intermittent failure, the system is OK a
Refueling
1. Park with the driver’s side closest
to the service station pump.
2. Open the fuel fill door by pulling
on the handle located under the
lower left corner of the dashboard.
3. Remove the fuel fill cap slowly.
You may hear a hissing sound as
pressure inside the tank equalizes.
The
© 2016-2025 Copyright www.hcrv.net
