Honda CR-V: Parking Brake
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Parking Brake
To apply the parking brake, push the pedal down with your foot. To release it, push on the pedal again.
The parking brake indicator on the instrument panel should go out when the parking brake is fully released.
Driving the vehicle with the parking brake applied can damage the rear brakes and hubs. A beeper will sound if the vehicle is driven with the parking brake on.
READ NEXT:
Steering Wheel Adjustment
Make any steering wheel adjustment
before you start driving.
Adjusting the steering wheel
position while driving may
cause you to lose control of the
vehicle and be seriously injured
in
Keys and Locks
The master key fits all the locks on
your vehicle. The valet key works
only in the ignition and the driver’s
door lock. You can keep the glove
box locked when you leave your
vehicle an
Immobilizer System
The immobilizer system protects
your vehicle from theft. If an
improperly coded key (or other
device) is used, the engine’s fuel
system is disabled.
When you turn the ignition switch to
t
SEE MORE:
Navigation System
Component Location Index
GPS ANTENNA
Removal/Installation
NAVIGATION
MICROPHONE
(Inside the map light)
Replacement
NAVIGATION UNIT
Removal/Installation
REARVIEW CAMERA
Removal/Installation
VOICE CONTROL SWITCH
Test
Replacement
PCM
Steering
Special Tools
Piston Seal Ring Sizing Tool
Bushing Base
Piston Seal Ring Guide
Cylinder End Seal Slide
Locknut Wrench, 40 mm
Ball Joint Remover, 28 mm
Valve Seal Ring Sizing Tool
Sleeve Seal Ring Guide
Pulley Holder
Sleeve Seal Ring Sizing Tool, 36 mm
P/S Joint Adapter (pump)
P/S Join
© 2016-2025 Copyright www.hcrv.net
