Honda CR-V: Power Door Locks

To lock all doors and the tailgate,

To lock all doors and the tailgate, push the top of the master door lock switch on either front door, pull the lock tab rearward on the driver’s door, or use the key on the outside lock on the driver’s door.

Pushing the rear of either master door lock switch will unlock all doors and the tailgate. Pushing forward the lock tab on the driver’s doors unlocks only that door.

The lock tab on any passenger’s door

The lock tab on any passenger’s door locks and unlocks that door.

When the door is unlocked, you can see the red indicator on the lock tab above the inner door handle.

All doors and the tailgate can be locked from the outside by using the key in the driver’s door lock. To unlock only the driver’s door, insert the key, turn the key, and release it.

The remaining doors and the tailgate unlock when you turn the key a second time within a few seconds.

To lock any passenger’s door when getting out of the vehicle, pull the lock tab rearward and close the door.

To lock the driver’s door, remove the key from the ignition switch, pull the lock tab rearward or push the top of the master switch, then close the door.

Lockout Prevention

With any door and the tailgate open and the key in the ignition, locking with master door lock switches is disabled. The lock tab on the driver’s door is not disabled if the driver’s door is closed. Pulling the driver’s lock tab rearward will lock all doors and the tailgate. If you try to lock an open driver’s door by pulling the lock tab rearward, the lock tab on the driver’s door pops out and unlocks the driver’s door.

READ NEXT:

 Auto Door Locking/Unlocking

Your vehicle has customizable settings for the doors and tailgate to automatically lock and unlock. There are default settings for each of these features. You can turn off or change the sett

 Auto Door Locking

The auto door locking feature has three possible settings: The auto door locking is deactivated all the time. The doors and tailgate lock whenever you move the shift lever out of the Park (P

 Auto Door Unlocking

The auto door unlocking feature has five possible settings: The auto door unlocking is deactivated all the time. The driver’s door unlocks when you move the shift lever to the Park (P) pos

SEE MORE:

 Driveshaft Inspection

1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and boot bands. 2. Turn the driveshaft by hand, and make sure the splines (E) and joint are not excessively loose. 3.

 APP Sensor Signal Inspection

NOTE: This procedure checks the APP sensor in its fully closed position. In any other position, the APP sensor stores DTCs which are covered in other troubleshooting procedures. Check for Temporary DTCs or DTCs with the HDS before doing this procedure. If any DTCs are indicated, troubleshoot

© 2016-2025 Copyright www.hcrv.net