Honda CR-V: Loading CDs in the Changer

Your vehicle has the CD changer in the center console.

CD-R, CD-RWdisc, and CD compressed inMP3 andWMA will not work in this unit. Video CDs and DVD discs also will not work.

Do not spill any liquids on the center console. Spilled liquids can damage electrical components in the CD changer.

1. Open the center console cover,

1. Open the center console cover, then slide open the CD changer cover by pulling it rearward.

2. Push the EJECT button to remove

2. Push the EJECT button to remove the CD magazine. The magazine will pop up automatically.

3. To install a CD into the magazine,

3. To install a CD into the magazine, push the button while pulling out on the tab.

4. Put a CDon the tray with the printed surface facing up as shown.

5. Reinstall the tray in the magazine.

Repeat this procedure to open the other five trays.

6. Store all six trays in the magazine,

6. Store all six trays in the magazine, and reinstall the magazine in the CD changer as shown.

7. Make sure to slide the CD changer cover closed until it clicks.

To remove CDs from the CD changer, refer to the loading procedure.

READ NEXT:

 To Play a CD

To play CDs, the ignition switch must be in the ACCESSORY (I) or ON (II) position. You operate the CD changer with the same controls used for the indash disc player or the radio. To select

 To Stop Playing a CD

Press the AM/FMor CD/XM button to switch to the radio or satellite radio while a CD is playing. If there is a PC card in the audio unit, touch the CARD icon to switch to the PC card while a C

 CD Changer Error Messages (EX-L model with navigation system)

If you see an error message in the display while playing a disc, find the cause in the chart to the right. If you cannot clear the error message, take your vehicle to your dealer. The cha

SEE MORE:

 Valve Clearance Adjustment

Special Tools Required Adjuster 07MAA-PR70110 Locknut wrench 07MAA-PR70120 NOTE: Adjust the valves only when the cylinder head temperature is less than 100 ºF (38 ºC). 1. Remove the cylinder head cover. 2. Set the No.1 piston at top dead center (TDC). The punch mark (A) on the variable valve

 Entry Lights Control System

Component Location Index With moonroof INDIVIDUAL MAP LIGHTS IGNITION KEY SWITCH IGNITION KEY LIGHT CEILING LIGHT CARGO AREA LIGHT RIGHT REAR DOOR SWITCH FRONT PASSENGER'S DOOR SWITCH LEFT REAR DOOR SWITCH DRIVER'S DOOR SWITCH DRIVER'S DOOR LOCK KNOB SWITCH MICU (Built into the under

© 2016-2025 Copyright www.hcrv.net