Honda CR-V: Driver’s Seat Power Adjustments

EX-L and Canadian EX models

See pages for important safety information and warnings about how to properly position the seats and seatbacks.

The controls for the power adjustable driver’s seat are on the outside edge of the seat bottom. You can adjust the seat with the ignition switch in any position. Make all seat adjustments before you start driving.

The front passenger’s seat can be adjusted manually (see the next page).

Moves the seat forward

Moves the seat forward and backward.

Moves the front of the

Moves the front of the seat up or down.

Raises or lowers the seat.

Raises or lowers the seat.

Moves the whole seat up

Moves the whole seat up and forward, or down and backward. The front of the seat also tilts up or down at the same time.

Adjusts the seat-back

Adjusts the seat-back angle forward or backward.

Increases or decreases

Increases or decreases the lumbar support.

READ NEXT:

 Seat Adjustments

LX and U.S. EX models See pages for important safety information and warnings about how to properly position the seats and seatbacks. Make all seat adjustments before you start driving. T

 Rear Seat Adjustments

To adjust the seats forward and backward, pull up on the lever under the seat cushion. After moving the seat, make sure it is locked into position. The angle of each rear seat-back can

 Armrests

Each front seat has an armrest on the side of the seat-back. To use it, pivot it down. The rear seat armrest is in the center of the rear seat. Pivot it down to use it.

SEE MORE:

 Differential Mount Replacement

Exploded View Differential Installation 1. Install rear differential mount assembly A to the rear differential assembly (B). 2. Jack up the rear differential. 3. Install the new set rings (A) onto the driveshafts, then insert the drives hafts into the rear differential. 4. Lift the rear different

 Replacing a Front Turn Signal Light Bulb

1. Open the hood. To change the turn signal bulb on the driver’s side, remove the engine coolant reserve tank by pulling it out of its holder. 2. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise. 3. Pull the bulb straight out of its s

© 2016-2025 Copyright www.hcrv.net