Honda CR-V: To Change or Select Files
Use the SKIP button while a USB flash memory device is playing to change files.
SKIP - Each time you press the
(SKIP +) button, the system
skips forward to the beginning of the
next file. Press the 
(SKIP -)
button, to skip backward to the
beginning of the current file. Press it
again to skip to the beginning of the
previous file.
To move rapidly within a file, press
and hold either side ( or )
of the SKIP button.
READ NEXT:
To Select a File from Folder and File Lists
You can also select a folder or file by
using the VOL/SELECT knob. Push
the VOL/SELECT knob to switch
the display to the folder or file list,
then turn the VOL/SELECT knob to
select a folder
To Stop Playing a USB Flash Memory Device
To play the radio when a USB flash
memory device is playing, press the
FM, AMor XMbutton. If a disc is in
the audio unit, press the CD/AUX or
CD button to play the disc.
Disconnecting a USB Flash Memory Device
You can disconnect the USB flash
memory device at any time even if
the USB mode is selected on the
audio system. Always follow the USB
flash memory device’s instructions
when you remove it
SEE MORE:
Seat Heaters
Component Location Index
DRIVER'S SEAT
HEATER RELAY (HIGH)
DRIVER'S SEAT
HEATER RELAY (LOW)
DRIVER'S SEAT CUSHION HEATER
DRIVER'S SEAT-BACK HEATER
FRONT PASSENGER'S
SEAT-BACK HEATER
FRONT PASSENGER'S
SEAT CUSHION HEATER
FRONT PASSENGER'S SEAT
HEATER RELAY (HIGH)
FRONT PASSENGER'S SE
Cylinder Head Installation
1. Install a new coolant separator in the engine block
whenever the engine block is replaced.
2. Clean the cylinder head and block surface.
3. Install the new cylinder head gasket (A) and dowel
pins (B) on the engine block. Always use a new
cylinder head gasket.
Set the crankshaft to top dead cen
© 2016-2025 Copyright www.hcrv.net
