Honda CR-V: Driving Guidelines

Your vehicle has higher ground clearance that allows you to travel over bumps, obstacles, and rough terrain. It also provides good visibility so you can anticipate problems earlier.

Because your vehicle rides higher off the ground, it has a high center of gravity that can cause it to roll over if you make abrupt turns. Utility vehicles have a significantly higher roll over rate than other types of vehicles.

To prevent rollovers or loss of control:

Take corners at slower speeds than you would with a passenger vehicle.

Avoid sharp turns and abrupt maneuvers whenever possible.

Do not modify your vehicle in any way that would raise the center of gravity.

Do not carry heavy cargo on the roof.

Four-wheel drive models

Your vehicle is equipped with a fourwheel drive (4WD) system. When the system senses a loss of frontwheel traction, it automatically transfers some power to the rear wheels. This gives you better traction and mobility.

READ NEXT:

 Preparing to Drive

You still need to exercise the same care when accelerating, steering, and braking that you would in a twowheel drive vehicle. 1. Make sure all windows, mirrors, and outside lights are clean a

 Starting the Engine

1. Apply the parking brake. 2. In cold weather, turn off all electrical accessories to reduce the drain on the battery. 3. Make sure the shift lever is in Park. Press on the brake pedal. 4. W

 Automatic Transmission

SEE MORE:

 DTC P1683: Throttle Valve Default Position Spring Performance Problem

CAUTION Do not insert your fingers into the installed throttle body when you turn the ignition switch ON (II) or while the ignition switch is ON (II). If you do, you will seriously injure your fingers if the throttle valve is activated. NOTE: Before you troubleshoot, record all freeze data and any o

 Transmission End Cover

End Cover Removal Special Tools Required Mainshaft holder 07GAB-PF50101 or 07GAB-PF50100 NOTE: The illustration shows the 4WD transmission; the 2WD is similar. 1. Remove the cooler inlet line bolt (D), sealing washers, and line bracket bolts (E), and remove the ATF cooler inlet line (F). 2. Remove

© 2016-2025 Copyright www.hcrv.net