Honda CR-V: Windshield Wipers and Washers

READ NEXT:

 Windshield Wiper

1. MIST 2. OFF 3. INT Intermittent 4. LO Low speed 5. HI High speed 6. Windshield washers Push the right lever up or down to select a position. MIST - The wipers run at high speed until

 WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

SEE MORE:

 DTC P16CO: PCM A/T Control System Incomplete Update

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is indicated when PCM updating is incomplete. 1. Update the A/T software in the PCM. 2. Check whether the DTC P16CO is indicated in the DTCs/Freeze Data

 Alternator and Regulator Circuit Troubleshooting

1. Make sure the battery connections are good and the battery is sufficiently charged. 2. Connect a VAT-40 (or equivalent tester), and turn the selector switch to position 1 (starting). 3. Start the engine. Hold the engine speed at 3,000 rpm with no load until the radiator fan comes on, then let i

© 2016-2025 Copyright www.hcrv.net