Honda CR-V: Selecting a Child Seat
When buying a child seat, you need to choose either a conventional child seat, or one designed for use with the Lower Anchors and Tethers for CHildren (LATCH) system.
Conventional child seats must be secured to a vehicle with a seat belt, whereas LATCH-compatible seats are secured by attaching the seat to hardware built into each rear seating position in the back seat.
Since LATCH-compatible child seats are easier to install and reduce the possibility of improper installation, we recommend selecting this style.
In seating positions and vehicles not equipped with LATCH, a LATCHcompatible child seat can be installed using a seat belt.
Whatever type of seat you choose, to provide proper protection, a child seat should meet three requirements:
1. The child seat should meet Federal Motor Vehicle Safety Standard 213 or Canadian Motor Vehicle Safety Standard 213.
Look for FMVSS 213 or CMVSS 213 on the box.
2. The child seat should be of the proper type and size to fit the child.
Rear-facing for infants, forwardfacing for small children.
3. The child seat should fit the vehicle seating position (or positions) where it will be used.
Before purchasing a conventional child seat, or using a previously purchased one, we recommend that you test the seat in the specific vehicle seating position or positions where the seat will be used.
READ NEXT:
Installing a Child Seat
After selecting a proper child seat
and a good place to install the seat,
there are three main steps in
installing the seat:
1. Properly secure the child seat to
the vehicle. All child seats
Installing a Child Seat with LATCH
Your vehicle is equipped with
LATCH (Lower Anchors and
Tethers for CHildren) at the rear
seats to secure a child seat in any
seating position: one in each outer
seating position, or one in t
Installing a Child Seat with a Lap/Shoulder Belt
When not using the LATCH system,
all child seats must be secured to the
vehicle with the lap part of a lap/
shoulder belt.
In addition, the lap/shoulder belts in
all seating positions except
SEE MORE:
Removing Discs from the In-dash Disc Changer
To remove the disc currently in play,
press the eject button. When a disc is
removed from a slot, the system
automatically begins the load
sequence so you can load another
disc in that position. If you do not
remove the disc from the changer
within 10 seconds, the disc will
reload in
If You Get Stuck
Avoid driving on soft sand, deep mud,
or other surfaces where you could
get stuck. If you do happen to get
stuck because of inclement weather
or other conditions, choose a safe
and appropriate course of action.
You should never use a jack to try
getting unstuck. A jack only works
on f
