Honda CR-V: Fuel Fill Door

Fuel Fill Door Adjustment

1. Remove the nut (A), then remove the open spring (B).

Honda CR-V. Fuel Fill Door

2. Slightly loosen the hinge mounting bolts (A).

Honda CR-V. Fuel Fill Door

3. Adjust the fuel fill door (B) in or out until it's flush with the body, and up or down as necessary to equalize the gaps.

4. Tighten the hinge mounting bolts.

5. Check that the fuel fill door opens properly and locks securely, and check that the rear of the door is flush with the body.

6. Reinstall the open spring and nut.

7. Apply multipurpose grease to each location indicated by the arrows.

Honda CR-V. Fuel Fill Door

8. Apply touch-up paint to the hinge mounting bolts and around the hinges.

Fuel Cap Adapter Replacement

NOTE: Take care not to scratch the body.

1. Remove the fuel pipe protector.

2. Remove the cap (A) by turning it counterclockwise.

Honda CR-V. Fuel Fill Door

3. From under the body, push out the hooks (A). Then turn the fuel cap adapter (B), and remove it from the fuel pipe.

Honda CR-V. Fuel Fill Door

4. Install the adapter in the reverse order of removal.

READ NEXT:

 Exterior Trim

 Upper/Lower Front Grille Replacement

Upper Front Grille Replacement NOTE: Take care not to scratch the bumper and grille. 1. Remove the front bumper. 2. Remove the clips from the back of the front grille and release the hooks (A), then

 Cowl Cover Replacement

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Take care not t

SEE MORE:

 Immobilizer System

Component Location Index IMMOBILIZER INDICATOR IMMOBILIZER-KEYLESS CONTROL UNIT (Built-in receiver) UNDER-DASH FUSE/RELAY BOX IMOES UNIT (Built into the MICU) PCM IGNITION KEY TRANSPONDER (Combined with the keyless transmitter) System Description The vehicle is equipped with an im

 DTC Troubleshooting

DTC B1000: Communication Bus Line Error (Bus-off) 1. Clear the DTCs with the HDS. 2. Turn the ignition switch OFF, and then back ON (II). 3. Wait for 6 seconds or more. 4. Check for DTCs with the HDS. Is DTCs B1000 and/or B1008 and B1011 indicated? YES-Go to step 5. NO-Intermittent failure, the

© 2016-2025 Copyright www.hcrv.net