Honda CR-V: WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

READ NEXT:

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

 Daytime Running Lights

With the headlight switch in the off or position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II)

SEE MORE:

 DTC P2227: BARD Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P0101, P0108, P1128, and/or P1129 are stored at the same time as DTC P2221, troubleshoot those DTCs first, then recheck for DTC P2221. 1. Turn the ignit

 Calculating Fuel Economy

Measuring Techniques Direct calculation is the recommended source of information about your actual fuel economy. Using frequency of fill-ups or taking fuel gauge readings are NOT accurate measures of fuel economy. Fuel economy may improve over the first several thousand miles (kilomet

© 2016-2026 Copyright www.hcrv.net