Honda CR-V: Reporting Safety Defects (U.S. Vehicles)

Honda CR-V (2006–2011) Owner's Manual / Warranty and Customer Relations / Reporting Safety Defects (U.S. Vehicles)

If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying American Honda Motor Co., Inc.

If NHTSA receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and remedy campaign.

However, NHTSA cannot become involved in individual problems between you, your dealer, or American Honda Motor Co., Inc.

To contact NHTSA, you may call the Vehicle Safety Hotline toll-free at 1-888-327-4236БЮ (TTY: 1-800-424-9153); go to http://www.saf ercar.gov; or write to:
Administrator, NHTSA, 1200 New Jersey Avenue, SE., Washington, DC 20590.

You can also obtain other information about motor vehicle safety from http://www.saf ercar.gov.

READ NEXT:

 AuthorizedManuals

Purchasing Factory Authorized Manuals (U.S. only) The publications shown below can be purchased from Helm Incorporated. You can order by phone or online: - Call Helm Inc. at 1-800-782-4356 (credit

 Honda CR-V (2006–2011) Service Manual

 Introduction

How to Use This Manual This manual is divided into multiple sections. The first page of each section is marked with a black tab that lines up with its corresponding thumb index tab on this page and th

SEE MORE:

 EGR Passage Removal and Installation

Removal 1. Drain the engine coolant. 2. Remove the air cleaner housing. 3. Remove the harness holder (A) from the bracket, then remove the harness holder bracket (B). 4. Remove the upper radiator hose (A), heater hose (B), and water bypass hose (C). 5. Remove the air cleaner housing brackets. 6

 Shift Lever

Shift Lever Removal 1. Remove the following parts: Heater control panel Dashboard center panel Center lower covers 2. Shift the shift lever into the R position. 3. Remove the nut securing the shift cable end. 4. Unlock the retainer (A). 5. Rotate the socket holder retainer (A) counterclockw

© 2016-2025 Copyright www.hcrv.net