Honda CR-V: Accessory Power Sockets
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Interior Convenience Items / Accessory Power Sockets
Your vehicle has two or three accessory power sockets depending on the model.
To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position.
Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or less (10 amps).
None of the sockets will power an automotive type cigarette lighter element.
Make sure to put the socket cover back in place to prevent any small foreign objects from getting into the socket.
READ NEXT:
Console Compartment
EX-L model
Push the release knob to open or
close the console compartment, slide
the lid rearward.
Coat Hook
To use a coat hook, slide it out
slightly, then pull it down.
Make sure the coat hook is folded up
when you are not using it. This hook
is not designed for large or heavy
items.
Seat Under Tray
If equipped
Your vehicle has a seat under tray
located under the front passenger
seat. Use the tray by pulling on the
front center edge of the tray.
SEE MORE:
Conventional Brake Components
Special Tools
Brake Caliper Piston Compresor
Component Location Index
BRAKE SYSTEM INDICATOR
Circuit Diagram
Parking Brake Switch Test
Brake Fluid Level Switch Test
BRAKE HOSE and LINE
Inspection
Brake Hose Replacement
PARKING DRUM BRAKE
Inspection
Shoe Replace
DTC 11, 13, 15, 17: Wheel Sensor (Open/Short
to Body Ground/Short to Power)
1. Turn the ignition switch ON (II).
2. Check for DTCs with the HDS.
Is DTC 87 indicated with DTC 11,13,15, and/or 17
at the same time?
YES-Go to step 9.
NO-Go to step 3.
3. Clear the DTC with the HDS.
4. Turn the ignition switch OFF, then turn it ON (II)
again.
5. Check for DTCs with the HDS.
© 2016-2025 Copyright www.hcrv.net
