Honda CR-V: Glove Box Removal/Installation
NOTE: Take care not to scratch the dashboard and related parts.
1. Open the glove box (A), and detach the hook (B) of the glove box damper. While holding the glove box, release the glove box stop (C) on each side from the dashboard by pushing them in.
2. Close the glove box (A), then remove the bolts and remove the glove box.
3. Install the glove box in the reverse order of removal.
Glove Box Damper Replacement
NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the dashboard and related parts.
1. Remove the these items:
- Glove box
- Dashboard side cover, passenger's side
2. Detach the clip of the glove box damper (A) by pinching it to release from inside the dashboard, then remove the damper.
3. Install the damper in the reverse order of removal.
Glove Box Striker Replacement
NOTE: Take care not to scratch the dashboard and related parts.
1. For some models: Remove the glove box light (A).
2. Detach the hook of the glove box damper and release the glove box stop on each side from the dashboard by pushing them inside (see step 1).
3. Remove the screws, then remove the glove box striker (B).
4. Install the striker in the reverse order of removal.
Dashboard Glove Box Cover Removal/Installation
NOTE: Take care not to scratch the dashboard and related parts.
1. Remove the dashboard/steering hanger beam.
2. Remove the steering/steering hanger beam from the dashboard.
3. Remove the screws, then remove the dashboard glove box center cover (A) or the dashboard glove box outer cover (B).
Center
Outer
4. Install the cover in the reverse order of removal.
READ NEXT:
Column Cover Removal/Installation
SRS components are located in this area. Review the
SRS component locations and the
precautions and procedures before
doing repairs or service.
NOTE: Take care not to scratch the dashboard and
relate
Seats
Component Location Index
REAR SEAT
Removal/Installation
Armrest Removal/Installation
Armrest Cover Replacement
Right Rear Seat Cover Replacement
Left Rear Seat Cover Replacement
Right S
Front Seat
Front Seat Active Head Restraint Inspection
NOTE: If the vehicle has been in a collision, always
inspect the active head restraints, even if they appear
reusable, by doing the following procedure.
Res
SEE MORE:
To Play a PC Card
You operate the PC card player with
the same controls used for the radio
and the disc player. To load or play a
card, the ignition switch must be in
the ACCESSORY (I) or ON (II)
position.
The PC card player reads and plays
cards in MP3 or WMA formats.
Depending on the format, the scree
Rear Window Wiper and Washer
1. OFF
When you turn the wiper switch to
the ‘‘OFF’’ position, the wiper will
return to its parked position.
2. Rotate the switch clockwise to
turn the rear window wiper ON.
The wiper operates every 7
seconds after completing two
sweeps.
3. Hold past ON to activate the rea
