Honda CR-V: Frame
Under-cowl Panel Replacement
NOTE: Take care not to scratch the body.
1. Remove these items:
- Windshield wiper arms
- Front fender trim, both sides
- Cowl covers
2. Remove the bolts and nuts, disconnect the
connector (A) and remove the grommet (B), then
remove the under-cowl panel (C).

3. Install the under-cowl panel in the reverse order of
removal.
Upper Dashboard Support Gusset Replacement
Upper Dashboard Support Gusset Torque
NOTE: Take care not to scratch the body.

Rear Damper Gusset Replacement
Rear Damper Gusset Torque
NOTE: Take care not to scratch the body.

Subframe Replacement
Front Subframe Torque
NOTE:
- After loosening the subframe mounting bolts, be sure to replace them
with new ones.
- When installing, align both installation reference holes in the subframe
with both reference holes in the body using
a screwdriver or tapered punch as a guide.

Rear Subframe Torque
NOTE:
- After loosening the subframe mounting bolts, be sure to replace them
with new ones.
- When installing, align both installation reference holes in the subframe
with both reference holes in the body using
a screwdriver or tapered punch as a guide.

Frame Repair Chart
Top View


Side View


READ NEXT:
Special Tools
Backprobe set
Component Location Index
SERVICE VALVE (HIGH-PRESSURE SIDE)
SERVICE VALVE (LOW-PRESSURE SIDE)
EVAPORATOR CORE (Located-in the heater unit)
RECEIVER/DRYER DESIC
WARNING
Compressed air mixed with the R-134a forms a
combustible vapor.
The vapor can burn or explode causing serious
injury.
Never use compressed air to pressure test
R-134a service equipment
The air conditioning system removes heat from the passenger compartment by
transferring heat from the ambient air
to the evaporator. The evaporator cools the air with the refrigerant that is
circula
SEE MORE:
1. Drain the engine coolant.
2. Remove the alternator.
3. Remove the condenser fan shroud assembly.
4. Remove the A/C compressor without disconnecting
the A/C hoses (see step 34).
5. Remove the intake manifold.
6. Remove the bolt (A) securing the connecting pipe.
7. Remove the lower radiator h
Security Alarm System
NOTE: This applies to EX and EX-L models.
The security alarm system is armed automatically after the doors, hood, and
tailgate are closed and locked. For the
system to arm, the ignition switch must be off, the key must be removed from the
ignition switch, and the MICU must
re
© 2016-2025 Copyright www.hcrv.net
