Honda CR-V: Door Lower Trim Replacement

NOTE:

1. Remove these items:

2. From the front or the rear door, remove the screw.

Honda CR-V. Exterior Trim

3. Using a utility knife, carefully cut the double-sided adhesive tape (A) along the edge of the door lower trim (B).

Front door

Honda CR-V. Exterior Trim

Rear door

Honda CR-V. Exterior Trim

4. With the help of an assistant, slide the door lower trim (A) rearward, and remove it. The clips (B, C) stay in the body. Turn the clips (B) 45 º counterclockwise, and remove them.

Front door

Honda CR-V. Exterior Trim

Rear door

Honda CR-V. Exterior Trim

5. Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.

6. Install the clips on the trim.

7. Scrape off the remaining double-sided adhesive tape from the trim and door, then clean the trim and door surfaces with a sponge dampened in isopropyl alcohol.

8. Apply primer to the area where the panel will be applied.

9. Attach the double-sided adhesive tape (A) to the trim (B), and fold the edge of each adhesive backing from the double-sided adhesive tape.

Front door

Honda CR-V. Exterior Trim

Rear door

Honda CR-V. Exterior Trim

10. Hold the trim (A) up, and fit all the clips (B, C) into the holes in the door, then push on the trim until the clips snap into place.

Front door

Honda CR-V. Exterior Trim

Rear door

Honda CR-V. Exterior Trim

11. Carefully pull the adhesive backing (D) away, and push the trim into place securely.

12. Set the screw into the back of clip, then reinstall the door speaker and the door panel.

READ NEXT:

 Side Windshield Trim Replacement

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Take care not t

 Fenderwell

Front Inner Fender Replacement NOTE: Take care not to scratch the body. 1. Remove the front wheel arch protector, as needed. 2. Remove the front inner fender (A). Remove the screws (B, C), and remo

 Openers

Component Location Index HOOD OPENER CABLE Replacement FUEL FILL DOOR OPENER Replacement TAILGATE LATCH Replacement FUEL FILL DOOR LATCH Replacement FUEL FILL DOOR OPENE

SEE MORE:

 If a Child Requires Close Attention

Many parents say they prefer to put an infant or a small child in the front passenger seat so they can watch the child, or because the child requires attention. Placing a child in the front seat exposes the child to hazards in a frontal collision, and paying close attention to a child

 Side Engine Mount Replacement

1. Support the engine with a jack and wood block under the oil pan. 2. Remove the power steering (P/S) fluid reservoir from the holder. 3. Remove the upper torque rod. 4. Remove the ground cable (A), then remove the side engine mount bracket (B). 5. Remove the side engine mount stiffener (A), th

© 2016-2025 Copyright www.hcrv.net