Honda CR-V: Using the Heater
The heater uses engine coolant to warm the air. If the engine is cold, it will be several minutes before you feel warm air coming from the system.
1. Select
.
When you select
, the system
automatically switches to fresh air
mode. If you switch the mode
from
or
, the system
also automatically turns on the
A/C. This helps prevent the
windows from fogging up
unintendedly. The A/C indicator
will not come on if it was off to
start with (see the first column on
this page).
2. Set the fan to the desired speed.
3. Adjust the warmth of the air with the temperature control dial.
READ NEXT:
Using the A/C
Air conditioning places an extra load
on the engine. Watch the engine
coolant temperature gauge. If it moves near the red zone,
turn off the A/C until the gauge
reading returns to normal.
1.
Dehumidify the Interior
Air conditioning, as it cools, removes
moisture from the air.When used in
combination with the heater, it
makes the interior warm and dry and
can prevent the windows from
fogging up.
1. Tur
To Defog and Defrost
To remove fog from the inside of the
windows:
1. Set the fan to the desired speed, or
high for faster defrosting.
2. Select
. The system
automatically switches to fresh air
mode and turns o
SEE MORE:
Automatic Transmission Fluid
Check the fluid level with the engine
at normal operating temperature.
1. Park the vehicle on level ground.
Start the engine, let it run until the
radiator fan comes on, then shut
off the engine. For accurate
results, wait about 60 seconds (but
no longer than 90 seconds) before
doing
Component Replacement/Inspection After
Deployment
NOTE:
Before doing any SRS repairs, use the HDS SRS
menu method to check for DTCs; refer to the DTC
Troubleshooting Index for the less obvious deployed
parts (seat belt tensioners, front impact sensors, side
airbag sensors, etc.)
Do not replace the ODS unit unless it is physically
damaged or
© 2016-2025 Copyright www.hcrv.net
