Honda CR-V: WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

READ NEXT:

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

 Daytime Running Lights

With the headlight switch in the off or position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II)

SEE MORE:

 Replacing a High-mount Brake Light Bulb

1. Open the tailgate. Unlatch the top of the cover by pulling back on it with your hands. 2. Place a cloth on the side edge of the cover to prevent scratches. Remove the cover by carefully prying on the edge with a small flat-tip screwdriver and pulling the cover off. 3. Remove the

 Headlight Adjustment

CAUTION Headlights become very hot during use; do not touch them or any attaching hardware immediately after they have been turned off. Before adjusting the headlights: Park the vehicle on a level surface. Make sure the tire pressures are correct. The driver or someone who weighs the same should

© 2016-2025 Copyright www.hcrv.net