Honda CR-V: Side Engine Mount Replacement
1. Support the engine with a jack and wood block
under the oil pan.
2. Remove the power steering (P/S) fluid reservoir
from the holder.
3. Remove the upper torque rod.

4. Remove the ground cable (A), then remove the side
engine mount bracket (B).

5. Remove the side engine mount stiffener (A), then
remove the side engine mount (B).

6. Install the side engine mount, then install the side
engine mount stiffener.
7. Install the side engine mount bracket (A), then
loosely tighten the new bolt and nut (B), and
loosely tighten the bolt (C).

8. Install the ground cable (D).
9. Remove the air cleaner housing assembly.
10. Loosen the transmission mounting bolt and nuts
(A).

11. Raise the lift to full height.
12. Loosen the lower torque rod mounting bolt (A).

13. Lower the vehicle on the lift.
14. Tighten the side engine mount mounting bolts and
nut.

15. Tighten the transmission mounting bolt and nuts.

16. Raise the lift to full height.
17. Tighten the lower torque rod mounting bolt.

18. Lower the vehicle on the lift.
19. Install the air cleaner housing assembly.
20. Install the upper torque rod, then tighten the new
upper torque rod mounting bolts in the numbered
sequence shown.

READ NEXT:
1. Loosen the upper torque rod mounting bolt (A).
2. Remove the air cleaner housing assembly.
3. Remove the powertrain control module (PCM)
cover, then remove the three bolts securing the
PCM.
4. R
1. Support the engine with a jack and wood block
under the oil pan.
2. Remove the upper torque rod.
3. Remove the ground cable (A), then remove the side
engine mount bracket (B).
4. Install the sid
Special Tools
Air Pressure Regulator
Valve Guide Reamer, 5.5 mm
Socket, 19 mm
Holder Handle
Adjuster
Locknut Wrench
Stem Seal Driver
VTEC Air Adapter
VTEC Air Stopper
Air Joint Adapter
C
SEE MORE:
Airbag System Components
Your airbag system includes:
Two SRS (supplemental restraint
system) front airbags. The driver’s
airbag is stored in the center of
the steering wheel; the front
passenger’s airbag is stored in the
dashboard. Both are marked ‘‘SRS AIRBAG’’
Two
The PC card slot is behind the
navigation screen. To use the PC
card player, press the OPEN button
beside the screen. The screen folds
back, and the PC card slot appears.
Insert a PC card straight into the slot.
The drive will read the PC card and
begin to play it.
Return the screen
© 2016-2025 Copyright www.hcrv.net
