Honda CR-V: Center Table
On LX and EX models
To use the center table, pull up the outside edge of the table until it latches. To store it, pull the lever and lower the table.
Sitting on or getting under the table, or putting heavy objects on the table, may damage or deform it.
Do not put any items on the table while driving. They may fall down or fly around when you go around corners or brake hard.
READ NEXT:
Lower Glove Box
Open the lower glove box by pulling
the bottom of the handle. Close it
with a firm push. Lock or unlock the
glove box with the master key.
The glove box light comes on when
the parking li
Upper Glove Box
Open the upper glove box by
pushing up the lever. Close it by
pulling down on the edge under the
lever.
Vanity Mirror
To use the vanity mirror on the back
of the sun visor, pull up the cover.
Except LX model
The vanity mirror lights come on
when you pull up the cover.
SEE MORE:
Low Oil Pressure Indicator Circuit
Troubleshooting (Open)
1. Connect the Honda Diagnostic System (HDS) to the
data link connector (DLC) (see step 2).
2. Turn the ignition switch ON (II).
3. Make sure the HDS communicates with the vehicle
and the powertrain control module (PCM). If it
doesn't communicate, troubleshoot the DLC circuit.
4. Check for DTCs.
APP Sensor Signal Inspection
NOTE:
This procedure checks the APP sensor in its fully
closed position. In any other position, the APP sensor
stores DTCs which are covered in other
troubleshooting procedures.
Check for Temporary DTCs or DTCs with the HDS
before doing this procedure. If any DTCs are
indicated, troubleshoot
© 2016-2025 Copyright www.hcrv.net
