Honda CR-V: Avoiding Obstacles

Debris in the road can damage your suspension or other components.

Because your vehicle has a high center of gravity, driving over a large obstacle, or allowing a wheel to drop into a deep hole can cause your vehicle to tip or roll over.

READ NEXT:

 Driving on Slopes

If you can’t clearly see all conditions or obstacles on a slope, walk the slope before you drive on it. If you have any doubt whether or not you can safely drive on the slope, don’t do i

 Crossing a Stream

Avoid driving through deep water. If you encounter water in your route (a small stream or large puddle, for example), evaluate it carefully before going ahead. Make sure it is shallow, flowi

 If You Get Stuck

Avoid driving on soft sand, deep mud, or other surfaces where you could get stuck. If you do happen to get stuck because of inclement weather or other conditions, choose a safe and appropria

SEE MORE:

 Lower Ball Joint Replacement

Special Tools Required Ball joint remover, 32 mm 07MAC-SL0A 102 Ball joint thread protector, 14 mm 071AF-S3VA000 1. Remove the front wheel. 2. Remove the flange bolt and flange nuts from the lower arm (A). NOTE: During installation, install a new flange bolt and new flange nuts. After lightly

 Rearview Camera and Monitor

On EX-L model with navigation system Whenever you shift to reverse (R) with the ignition switch in the ON (II) position, the rearview is shown on the navigation system screen. For the best picture, always keep the rearview camera clean, and do not cover the camera lens. To avoid scra

© 2016-2026 Copyright www.hcrv.net