Honda CR-V: Break-in Period

Help assure your vehicle’s future reliability and performance by paying extra attention to how you drive during the first 600 miles (1,000 km).

During this period:

Avoid full-throttle starts and rapid acceleration.

Do not change the oil until the scheduled maintenance time.

Avoid hard braking for the first 200 miles (300 km).

Do not tow a trailer.

You should also follow these recommendations with an overhauled or exchanged engine, or when the brakes are replaced.

READ NEXT:

 Fuel Recommendation

Your vehicle is designed to operate on unleaded gasoline with a pump octane number of 87 or higher. Use of a lower octane gasoline can cause a persistent, heavy metallic rapping noise that c

 Service Station Procedures

 Refueling

1. Park with the driver’s side closest to the service station pump. 2. Open the fuel fill door by pulling on the handle located under the lower left corner of the dashboard. 3. Remove th

SEE MORE:

 DTC Troubleshooting

DTC indicator 1: An Open in the Air Mix Control Motor Circuit 1. Start the engine. 2. Turn on the A/C, then set the temperature control dial to Max Hot. 3. Turn the ignition switch OFF and then ON (II). 4. Do the self-diagnostic with the HVAC control unit. 5. Check for DTCs. Is DTC 1 indicated?

 Floor Mats

The floor mats that came with your vehicle hook over the floor mat anchors. This keeps the floor mats from sliding forward, possibly interfering with the pedals, or backwards, making the front passenger’s weight sensors ineffective. If you remove a floor mat, make sure to re-anc

© 2016-2025 Copyright www.hcrv.net